This sort of micro servos can be utilized for helicopter, airplane, car and boat. It owns Top quality and high cost performance. In the interim, it is light weight and has a small size. I imagine this can be a good tool for you.
Specification:
Model: SG90
Weight: 9g
Stall torque: 1.8kg/cm
Operating speed: 0.1sec/60degree
Operating voltage: 4.8V
Temperature range: 0℃ ~ +55℃
Dead band width: 10us
Maximum rotation angle: 180 degrees
Gear medium: nylon
Working mode: Simulation
Circuit connection:
Yellow line (signal line)
Red line (power line)
Brown (ground)
Package includes:
4* SG90 9g Micro Servos
How to connect SG90 micro servo motor to Arduino Uno?
The connection with Arduino is extremely easy. The servo has three leads. The brown one is the Ground so connect to it Arduino Ground.
The red one is VCC which frequently requires a voltage between four points eight to seven point two volts. So connect it to Arduino 5V.
The last lead, the orange one is the keep watch over signal which needs to be a PWM signal with a periodic time of twenty milliseconds aka 50 Hertz
and a duty cycle of one to two milliseconds so five to ten percent.
At the same time as an on time of one millisecond represents the -90° position of the motor shafts, one point five milliseconds represent 0° position and
two milliseconds the plus 90° position. That means you’ll be able to rotate the shaft a total of 180°.
Make sure this fits by entering your model number.
Top quality and high cost performance.
Operating speed: 0.1second/ 60degree ( 4.8V no load)
Operating voltage: 4.8-6V
Small size and light weight.
Application: Used for fixed-wing, helicopter, KT, glider, small robot, robotic arm and other models.
[amz_corss_sell asin=”B07MLR1498″]
Reviews
There are no reviews yet.